1. Use isopropyl or rubbing alcohol to wash all wax and dirt from surface of car.
2. Make a wetting solution. (see chart below)
3. Lay the decal face down on a flat surface and peel off the backing of the sticker.
4. Spray the wetting solution on the sticky side of the decal and the area that you plan on placing the vinyl sticker.
5. Position the decal where you want it. Take a step back to eye up the alignment.
6. Use a squeegee to rub over the top of the sticker, to help get all of the water out and to help adhere the sticker.
7. Wait a few minutes, depending on the temperature, and then try to remove the top protective paper from vinyl. If the paper comes off and the vinyl stays in place, then you are finished. If the vinyl comes off, rather than staying on the car then rub the sticker back on to the car and wait longer.
8. Check your work the next day. If you find air bubbles, pierce them with a pin and gently work the air out of the area with your squeegee.
9. To ensure a permanent bonding, allow at least 72 hours in direct sunlight before washing or waxing.

For every 20oz H2O:
1/4 Teaspoon blue Dawn dish soap
1/2 Teaspoon >70% isopropyl alcohol

1. Use isopropyl or rubbing alcohol to wash all wax and dirt from surface of car.
2. Make a wetting solution. (see chart below)
3. Spray the wetting solution on the area that you plan on placing the decals.
4. Carefully remove the vinyl decal from the backing paper (remove one piece at a time if there are multiple pieces.
5. Position the decal where you want it. Take a step back to eye up the alignment.
6. Use a squeegee to rub over the top of the sticker, to help get all of the water out and to help adhere the sticker.
7. Check your work the next day. If you find air bubbles, pierce them with a pin and gently work the air out of the area with your squeegee.
8. To ensure a permanent bonding, allow at least 72 hours in direct sunlight before washing or waxing.

For every 20oz H2O:
1/4 Teaspoon blue Dawn dish soap